AQUASTOP E-96 SLOW CURE is 2:1, 100% solids, 0 VOC, two-component epoxy resin-based primer based on phenolic amine chemistry specifically designed as a moisture barrier for concrete floors with very high residual moisture prior to laying floor coverings, coatings, or parquet. (Up to 15 lbs/1,000ft2/24 hr.). Also suitable on calcium sulphate-based screeds with slightly higher residual moisture.
As a primer for absorbent, non-absorbent as well as smooth surfaces. For interior and exterior use.
Concrete slabs at ground level emit invisible moisture vapor. The permissible moisture emissions for concrete are 3 lb./1000ft2 over 24 hours (<4%) based on calcium chloride test. In addition, a relative humidity (RH) test can be performed to test for moisture vapor. Relative humidity test results should be less than 85% per ASTM F2170. If humidity is above this level, blistering and delamination of the coating may occur.
ADVANTAGES
-
Made from 100% solids.
- Resistant to chemical loadings
- Good penetration
- Can be applied to almost all substrates
- Grip promoting
- Suitable for application on subfloor heating systems.
- Resistant to bacteria and moisture
- Exceeds ASTM F3010 standards
- 0 VOC
- Suitable on damp substrates
- High sealing function
- For increased residual moisture and single-layer application
- Magnesite screeds
- Old sealed/coated surfaces
- Impermeable and seamless. Up to 15 lbs/1000ft2 /24 hr.
Kit:
Part A (2 Gal / 7.56 Liters) - Part B (1 Gal /3.78 Liters)
Technical Data Sheet
